Back Logo Next

Fitting the side bevel gears

First insert the conical gear from the lower side, being careful that the reference mark coincides with one of the two marks on the central conical gear. The other mark on the central gear is used to fit the conical gear on the opposite side.

Next, the thickness washers are fitted. Then fit the bearing holder bush. To do this, tool # 88713.0111 should be screwed on the bush itself. Then tap on the bush with a plastic hammer until it seats properly. Then fit the thickness washers and the seeger ring. The conical gear on the opposite side is fitted in the same manner.

Figure 42

Back Up Next